Your water heater is one pretty used and higher priced appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving with regards to your home heating and costs.

Regular flushing of your water heater is probably the single most important step you can take to prolong its service life and to save energy. A duration of time, sediments strengthen in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not merely destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most regarding the country, the average water heater lasts 3-5 years. Regularly flushing your water heater can double existence of your water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater ‘s very important in today’s economy. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of hot water your home uses, that can mean a savings of $20 to over $50 a month.

To drain your water heater, initially you should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it is an electric heater). Failure to do so could result in overheating and severe damage to water heater. Next, close the water supply valve located more than a water inlet line going into your water heater. You may then connect a garden hose to the drain valve located in the bottoom of the hot water heater. Open the drain and allow it to play until all for the water has emptied from the air conditioner. Then close the drain. Open the water supply valve and refill the heating. You should also open a hot water faucet somewhere at home and stand there and watch it run for several minutes until water flows out quietly. This will allow air to vent because of the heater and the hot water lines. Finally, you can turn the thermostat to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your home to filter or condition the water so it is less corrosive to your plumbing system, particularly in areas which have hard this type of water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your neighborhood to discuss options and products to provide what you need.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2

Will Heating and Piping Be Affected by one specific Slowing Economy?

You May Also Like